HP 5800 Series Configuration Guide

155
# Verify that the current boot files on the IRF member switches are soft-version2.bin.
[IRF] display boot-loader
Slot 1
The current boot app is: flash:/soft-version2.bin
The main boot app is: flash:/soft-version2.bin
The backup boot app is: flash:/
Slot 2
The current boot app is: flash:/soft-version2.bin
The main boot app is: flash:/soft-version2.bin
The backup boot app is: flash:/
Slot 3
The current boot app is: flash:/soft-version2.bin
The main boot app is: flash:/soft-version2.bin
The backup boot app is: flash:/
Performing incompatible ISSU upgrade
# Upgrade the specified subordinate switch (the new master after the upgrade), which is subordinate switch
2 in this example.
<IRF> system-view
[IRF] issu load file soft-version2.bin slot 2
This command will begin ISSU, and the specified board will reboot and be upgraded. Please
save the current running configuration first; otherwise, the configuration may be lost.
Continue? [Y/N]: y
# After the reboot of subordinate switch 2, reboot and upgrade all IRF member switches that have not been
upgraded.
[IRF] issu run switchover slot 2
Master will reboot, switch the specified chassis to master. Continue? [Y/N]:y
Then, the ISSU upgrade process completes and the boot files of all IRF member switches have been
upgraded to the new version.

HP 5800 Series Specifications

General

MAC Address Table Size	32, 000 entries
Uplink Ports	2 or 4 SFP+ 10GbE ports
Routing Protocol	BGP, IS-IS
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 95% (noncondensing)
PoE	Optional
Power Supply	Redundant power supply (optional)