HP 5800 Series

30
Procedure
To configure none authentication for console login:
Step Command Remarks
1. Enter system view. system-view —
2. Enter AUX user interface view.
user-interface aux
first-number
[ last-number ]
—
3. Specify the none
authentication mode.
authentication-mode
none
Required.
By default, log in to the device through the
console port without authentication, and have
user privilege level 3 after login.
4. Configure common settings
for AUX user interface view.
—
Optional.
See “Configuring common settings for console
login (optional).”
After the configuration, the next time you log in to the device through the console port, you are prompted to
press enter. A prompt such as <HP> appears after you press Enter, as shown in Figure 7.
Figure 7 Configuration page
Configuring password authentication for console login
Prerequisites
You have logged in to the device.