HP 5800 Series

39
Ste
p
Command Remarks
5. Configure the command level
for login users on the current
user interfaces.
user privilege level level
Required.
By default, the default command level is 0
for VTY user interfaces.
6. Configure common settings
for VTY user interfaces.
—
Optional.
See “Configuring common settings for VTY
user interfaces (optional).”
When you log in to the device through Telnet again:
• You enter the VTY user interface, as shown in Figure 11.
• If “A
ll user interfaces are used, please try later!” is displayed, it means the current login users exceed the
maximum number. Please try later.
Figure 11 Configuration page