HP 650 User Manual

Note Do not wait more than 5 seconds after step 2 below. Holding the Clear
button too long prevents this procedure from working.
1. Press the Reset button, and while holding it down, immediately press
and hold the Clear button.
All LEDs are lit while Reset is pressed. (All Card LEDs are orange,
and all Self-test LEDs are green.)
2. Release the Reset button, but continue to hold the Clear button.
The Card LEDs turn orange, and the Self-test LED for the routing
engine begins flashing.
3. Release the Clear button within five seconds.
Note If the Self-test LED has stopped flashing (and the Status LED has turned
orange), you waited too long—prevents this procedure from working. If
this happens, recover by restarting the procedure. (If a console is
connected, the interface for RMON will appear; you can ignore it and
restart the procedure.)
The Self-test LED stops flashing and remains lit during the self-test
portion of the initialization sequence. (For more information about
this, see “Initialization Sequence” below on page 2-15.) This self-test
lasts about 8 seconds. The Self-test LED goes off when the self-test is
complete (if no failures have been detected).
4. You may need to press [Return] more than once to get console access.
Description and Operation
LEDs and Buttons
2-13

HP 650 Specifications

General

RAM	Up to 8GB DDR3
Display	15.6-inch HD (1366x768)
Graphics	Intel HD Graphics
Operating System	Windows 7 / Windows 8
Battery	6-cell Li-ion
Optical Drive	DVD±RW
Wireless	802.11b/g/n
Processor	Intel Celeron, Pentium, or Core i3/i5/i7 (various models available)