HP 830 - Slide Rails; Installing the Switch by Using Front and Rear Mounting Brackets

11
Figure 6 Rear mounting bracket
(1) Screw holes for fixin
g
the rear mountin
g
bracket onto the rack (usin
g
M6 screws)
(2) Heat dissipation holes
Slide rails
The slide rails are optional components that need to be separately ordered.
Figure 7 Slide rail
(1) Slot hole for fixing the slide rail onto the rear bracket of the rack. It allows adjustment of the switch mounting
screw position accordin
g
to the switch position.
(2) Heat dissipation holes. Holes for
heat dissipation between the switch and the rack.
(3) Slot hole for fixing the slide rail onto the front bracket of the rack.
Installing the switch by using front and rear mounting brackets
1. Wear an ESD-preventive wrist strap, and make sure the rack is sturdy and properly grounded.
2. Mark the position on the rack for installing the slide rail, and install the cage nuts.