32
Hardware management and maintenance
The CLI and outputs depend on the software version that is running on the switch.
Logging in to the switching engine by using OAP
You can log in to the operating system of the switching engine from the controller engine side. Then the
command line interface is switched from the controller engine to the switching engine, where you can
manage the switching engine's system and application software. To return to the command line interface
of the controller engine, press Ctrl + K.
To log in to the switching engine by using OAP at the controller engine side:
Task Command Remarks
Log in to the switching engine by using
OAP at the controller engine side.
oap connect slot slot-number
Required.
Available in user view.
Displaying hardware information for the switch
Displaying software and hardware version information for the
controller engine
Use the display version command to display software and hardware version information about the switch.
The output includes the following information: the current software version, the hardware version, and the
switch operating time. The output depends on the software and hardware version of the switch.
• On the controller engine:
[HP]display version
HP Comware Platform Software
Comware Software, Version 5.20, Beta 3308P16
Copyright (c) 2010-2013 Hewlett-Packard Development Company, L.P.
HP 830 24P uptime is 0 week, 0 day, 0 hour, 55 minutes
HP 830 24P with 1 RMI XLS 208 750MHz Processor
512M bytes DDR2
1024M bytes Flash Memory
Hardware Version is Ver.A
CPLD Version is 006
Basic Bootrom Version is 2.00
Extend Bootrom Version is 2.00
[Slot 0]830 24P LSW Hardware Version is NA
[Slot 1]830 24P Hardware Version is Ver.A
• On the switching engine:
To Next Page
Loading...
