24
Figure 28 Setting the terminal emulation
Connecting the Ethernet cables
Connecting a copper Ethernet port
1. Connect one end of the Ethernet cable to the copper Ethernet port on the switch, and the other end
to an Ethernet port of the peer switch.
2. After powering on the switch, examine the LEDs of the fixed copper Ethernet port.
For more information about the LED description, see "Appendix A Chassis views and tec
hnical
specifications."
Connecting a fiber Ethernet port
hen you connect a fiber:
• Never bend or curve a fiber with a fierce force. The bend radius of a fiber must not be less than 10 cm
(3.94 in).
• Make sure the TX and RX ports on a transceiver module are correctly connected.
• Keep the fiber end clean.
The switch does not include a transceiver module. HP transceiver modules are recommended. For
transceiver module specifications, see "Appendix A Chassis views and technical specifications."
T
o connect a 1000 Mbps fiber port:
To Next Page
Loading...
