38
Displaying the exception handling method
Use the display system-failure command to display the exception handling method.
<HP> display system-failure
System failure handling method: reboot
Rebooting the switch
CAUTION:
• If the main system software image file has been corrupted or does not exist, the device cannot reboot.
You must re-specify a main system software image file, or power off the device and then power it on so
the system can reboot with the backup system software image file.
• Save your configuration before device reboot to avoid data loss. The device displays "REBOOT IN ONE
MINUTE" 1 minute before it is rebooted.
• For security purposes, if you are performing file operations at the reboot time, the system does not
reboot.
When upgrading and maintaining the system software image file or the configuration file for the switch,
you must reboot the switch. To reboot a switch, use one of the following methods:
• Reboot the switch immediately at the CLI.
• Schedule a reboot at the CLI to occur at a specific time and date or after a delay.
• Power off and then power on the switch again. Because this method can cause data loss. HP
recommends using one of the CLI methods.
To reboot the switch immediately:
Task Command Remarks
Reboot the switch immediately. reboot
Required.
Available in user view.
To schedule a reboot for the switch:
Task Command Remarks
Schedule a reboot.
• Schedule a reboot to occur at a specific time
and date:
schedule reboot at hh:mm [ date ]
• Schedule a reboot to occur after a delay:
schedule reboot delay { hh:mm | mm }
Use either command.
The scheduled reboot function is
disabled by default.
Available in user view.
To Next Page
Loading...
