HP 830 - display vlan

37
Table 10 Command output
Field Description
Fan 1 Number of the fan.
State
Fan state:
• Normal—The fan is operating correctly.
• Absent—The fan is not in position.
• Fault—The fan has failed.
Displaying the operating state of a power supply
Use the display power command to display the operating state of a power supply.
<HP>display power
Power 1 State: Normal
Table 11 Command output
Field Description
Power 1 Number of the power supply.
State
Power supply state:
• Normal—The power supply is operating correctly.
• Absent—The power supply is not in position.
• Fault—The power supply has failed.
Configuring the exception handling method
Configuration procedure
You can configure the switch to handle system exceptions (such as system instruction faults, invalid
addresses, data overflow, null pointers, and division by zero operations) by using one of the following
methods:
• Reboot—The switch automatically reboots to recover from the error condition.
• Maintain—The switch stays in the error condition so you can collect complete data for diagnosis,
including error messages. You must manually reboot the switch.
To configure the exception handling method:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Specify the exception
handling method.
system-failure { maintain |
reboot }
Optional.
By default, the switch reboots when an
exception occurs.