HP 83522A User Manual

UPDATES
Page 1-2:
After paragraph 1-9 add the following:
Manufacturer's Declaration
NOTE NOTE
This is to certify that this product meets the radio
Hiqmit wird bescheinigt, dass dieses GeratlSystem
frequency interference requirements of Directive
in Ubereinstimmung mit den Bestimmungen von
FTZ 1046/1984. The German Bundespost has been
Pdstverfiigung 1046184 funkentst6x-t ist.
notified that this equipment was put into circulation
and has been granted the right to check the product
Der Deutschen Bundespost wurde das Inverkehr-
type for compliance with these requirements.
bringen dieses Geraes/Systems angezeigt und die
Berechtigung
zur Uberpriifung der Serie auf Ein-
haltung der Bestimmungen eingeraumt.
Note: If test and measurement equipment is oper-
ated with unshielded cables and/or used for mea-
Zusatlinfomation fiir Mess- und ~est~erate:
surements on open set-ups, the user must insure that
under these operating conditions, the radio fie-
Werden Mess- Testgerate mit ungeschimten
quency interference limits are met at the border of
ICabeln und/oder in offenen Messaufbauten ver-
his premises.
wendet, so ist vom
Betreiber sicherzustellen, dass
. die Funk-Entstorbestimmungen unter Betriebs-
Model HP 83522A
bedingungen an seiner Grundstucksgrenze ein-
gehalten werden.
Page 1-3, Table 1-1:
Under
"Power Variation, Internally Leveled," add the following specification:
"With Option 002: + 0.35 dB (in 0 dB attenuation step)."
Delete all references to Stability
With Time (in a 10 minute period after one hour warmup).
Page 1-4, Table 1-2:
Add
the following typical characteristic:
Power Variation
Internally Leveled (Option
002): + 0.5 dB (in 10 dB to 70 dB attenuation steps).
Add STABILITY WITH TIME (in a
10 minute period after one hour warmup at the same frequency setting):
< + 100 kHz.
Page 4-4, Table 4-2:
Under "4-14. Output Amplitude, Internally Leveled: 2.25 dB," add the following:
"Opt.
002: + 0.35 dB."
Page
4-5, Table 4-2, Section 4-15:
Delete all references to Time (10 minutes): specifications.
Page 5-1, Paragraph
5-1 1:
Replace Paragraph 5-12 with the following
Adjustment procedures are given in the proper sequence to allow for interrelated adjustments. However,
perform Paragraph
5-22 before Paragraph 5-21, all other adjustments should be done in order of appearance.
Adjustments having to do with the leveling loop (paragraph
5-20 through 5-24) are interactive and should be
performed as a group.
UPDATES
UPDATES APPLY TO ALL SERIALS

HP 83522A Specifications

General

Brand	HP
Model	83522A
Category	Inverter
Language	English