HP 8559A - 5-59

MODEL 8559A
ADJUSTMENTS
ADJUSTMENTS
5 - 28. FREQUENCY RESPONSE ADJUSTMENTS (Cont'd)
EQUIPMENT:
Sweep Oscillator
......................................................... HP 8620C
RF Plug - In (.01- 2.4 GHz) .............................................. HP 8622A/B
RF Plug - In (2 - 22 GHz) ............................................. HP 86290B - H08
Synchronizer
........................................................ HP 8709A - H 10
Power Meter
........................................................... HP 435A/B
Power Sensor (.Ol - 18 GHz) .............................................. HP 8481A
Power Sensor (.05 - 26.5 GHz) ............................................. HP 8485A
Crystal Detector (-01 - 26.5 GHz) .......................................... HP 33330C
20 dB Attenuator .............................................. HP 8491B, Option 020
Tuning Voltage Circuit
............................................ Refer to Figure 5 - 17
Cable,SMA(m)toSMA(m) ........................................... HP8120 - 1578
Cable, BNC (m) to SMC
(f) ........................................... HP 1 1592 - 60001
Adapter, Type N (m) to SMA
(f) (2 required) ............................... HP 1250 - 1250
Adapter, Type N
(f) to SMA (f) (2 required) ................................ HP 1250 - 1745
Adapter, Type N
(f) to Type N (f) ........................................ HP 1250 - 1472
Extender Cable Assembly
.............................................. HP 5060 - 0303
Powersplitter ......................................................... 11667A - C16
PROCEDURE:
1. Allow one
- half hour warmup time of equipment with analyzer connected to mainframe with extender
cable.
2. Connect equipment as shown in Figure 5
- 16 with power meter/power sensor connected to 20 dB attenua-
tor and HP 86222A/B (.01- 2.4 GHz plug - in) installed in sweep oscillator mainframe.
3. Set sweep oscillator controls
as follows:
Mainframe:
SWEEP MODE
.............................................................. EXT
MARKERS
................................................................. OFF
All rear panel switches
......................................................... OFF
Plug
- in
RFOFF/ON ................................................................. OFF
ALC
....................................................................... EXT
POWER LEVEL ....................................................... Fully CCW
FM/NORM/PL (rear - panel) ..................................................... PL
4.
Set synchronizer controls as follows:
POLARITY
...................................................................
-
SENSITIVITY ....................................................... 6 MHz/VOLT