HP 8560E - Replacement (Without Contact Removal Tool)

216 Chapter3
Assembly Replacement
Procedure 14. W3 Line Switch Cable (8560E)
Replacement (without Contact Removal Tool)
1. Lay the replacement line switch cable assembly between the side
frame and main deck. Ensure that the action of the switch is
working properly.
2. Attach the left side frame to the deck and rear frame. See Figure
3-34 on page 217.
Screw Quantity
(1) SCREW-MACH M4 X 0.7 8 mm-LG FLAT HD.............. 3
(2) SCREW-MACH M3 X 0.5 35 mm-LG FLAT HD............ 2
(3) SCREW-MACH M3 X 0.5 6 mm-LG FLAT HD.............. 6
3. Dress W3 between the main deck standoff and the side frame. See
Figure 3-32 on page 213.
4. Attach the A1 Front Frame assembly, following the A18 CRT
assembly instructions as described in steps 1 through 16 under
"Procedure 2B. A1 Front Frame/A18 CRT (8560E)."
5. Place LED A1W1DS1 into the line switch assembly.
6. Attach the line switch assembly into the front frame using the
captive panhead screw. Ensure the connection of the line switch
grounding lug to the screw.