HP 8560E - Adjustable and Factory-Selected Components

Chapter 2 53
Adjustment Procedures
Introduction
A5 IF IF Bandpass Adjustment 3
IF Amplitude Adjustment 4
A6 Power Supply High Voltage Power Supply Adjustment (8560E only) 1
Display Adjustment (8560E only) 2
A6A1 HV Module High Voltage Power Supply Adjustment (8560E only) 1
Display Adjustment (8560E only) 2
A7 1ST LO First LO Distribution Amplifier Adjustment 8
Distribution
Amplifier
Frequency Response Adjustment (or perform the
Frequency Response Performance Test in the
10
HP 8560 E-Series and EC-Series Spectrum Analyzer
Calibration Guide. The adjustment must be performed if
the performance test fails.)
A8 Low Band Mixer Frequency Response Adjustment 10
A9 Input
Attenuator
Frequency Response Adjustment (or perform the
Frequency Response Performance Test in the
10
HP 8560 E-Series and EC-Series Spectrum Analyzer
Calibration Guide. The adjustment must be performed if
the performance test fails.)
A10 Tracking
Generator
Tracking Generator Power Level Adjustment 9
Frequency Response Adjustment 10
A11 YTO YTO Adjustment 7
Frequency Response Adjustment (or perform the
Frequency Response Performance Test in the
10
HP 8560 E-Series and EC-Series Spectrum Analyzer
Calibration Guide. The adjustment must be performed if
the performance test fails.)
A13 2nd Converter Frequency Response Adjustment 10
A14 Frequency
Control
Display Adjustment (fast zero span) 2
YTO Adjustment 7
First LO Distribution Amplifier Adjustment 8
Frequency Response Adjustment 10
A15 RF 10 MHz Reference Adjustment (Option 103) 12
Calibrator Amplitude Adjustment 11
External Mixer Bias Adjustment 14
Sampling Oscillator Adjustment 6
Signal ID Oscillator Adjustment 16
External Mixer Amplitude Adjustment 15
Table 2-1 Related Adjustments
Assembly
Changed or
Repaired
Perform the Following Related Adjustments in the
Order Listed
Adjustment
Number