HP 8712ES - Page 335

ES User’s Guide 8-29
Hardkey/Softkey Reference
E
Softkey in the LAN port setup menu. Displays the Ethernet address,
which is a 48-bit number assigned at the factory to be used to identify a
machine on the network. The Ethernet address cannot be changed.
See The LAN Interface User’s Guide Supplement for more information.
Access Keys:
Softkey in the more display menu. Toggle to ON if you want to expand
the measurement display to the full screen size and eliminate all
annotation except marker annotation.
See “Expanding the Displayed Measurement” on page 4-52 for more
information.
Access Keys:
Softkey in the source . Toggle to ON if you want to set the
network analyzer to use the external 10 MHz signal as the frequency
standard. When the Ext Ref feature is toggled ON and a signal is not
present at the EXT REF IN connector, the network analyzer will not
sweep. Default is OFF.
NOTE The external reference should be disconnected
from the EXT REF IN or power reduced when not
in use.
Softkey in the trigger source menu. Enables the analyzer to sweep to
the next (frequency) point when externally triggered through the EXT
TRIG IN/OUT rear panel connector. The analyzer sweeps one point per
trigger.
Access Keys:
Softkey in the trigger source menu. Enables the analyzer to begin one
complete sweep when externally triggered.
Access Keys:
Ethernet
Address
SYSTEM OPTIONS
LAN
LAN Port Setup
Expand on OFF
DISPLAY
More Display
Ext Ref on OFF
MENU
External Point
MENU
Trigger
Trigger Source
External Sweep
MENU
Trigger
Trigger Source