HP 8712ES - Introduction

3-2 ES User’s Guide
Making Measurements
Introduction
Introduction
This chapter provides an overview of basic network analyzer
measurement theory, a section explaining the typical measurement
sequence, a segment describing the use of the key, and detailed
examples of the following measurements:
• “Measuring S-Parameters using a Two-Port Calibration” on page 3-19
• “Measuring S21 Forward Transmission using an Enhanced Response
Calibration” on page 3-41
• “Measuring S11 Reflection Port 1 using a One-Port Calibration” on
page 3-48
• “Making a Power Measurement using Broadband Detection” on
page 3-56
• “Measuring Conversion Loss” on page 3-61
• “Making Measurements with the Auxiliary Input” on page 3-67
• “Measuring Group Delay” on page 3-69
• “Measuring Impedance using the Smith Chart” on page 3-73
• “Measuring Impedance Magnitude” on page 3-80
BEGIN