port to an application layer
protocol for NAT ALG
2. The console interface of
A-MSR900/MSR900 and
A-MSR920/MSR920 support the
function of the auxiliary interface,
and Only the A-MSR900/MSR900
and A-MSR920/MSR920 which's
PCB versions are 3.0 or higher can
support this function.
Fixes bugs
Only support A-MSR9XX series and
MSR9XX series
Support A-MSR20_30_50_900 series
and MSR20_30_50_900 series
New features:
1. Support Sierra 313U modem
2. Support to auto-configure the
router by USB disk
3. Extend A-MSR50 OSPF maximum
area amount to 200
Fixes bugs
Support A-MSR20_30_50_900 series
and MSR20_30_50_900 series
New features:
1. Support to set the OEM flag of
A-MSR
2. Support to disable the USB port
using the command
Fixes bugs
Support A-MSR20_30_50_900 series
and MSR20_30_50_900 series
New features:
1. Support to set the OEM flag of
A-MSR router from HP to 3COM
using the command (can't be
supported at MSR3010/3011E/
3011F and MPU-G2)
2. Support to filter packets based
on MAC Addresses, and any
attempt to break this rule must to
be logged and to send a SNMP
trap
3. Support to assign IPv6 address of
/127 prefix on link interfaces
4. Judge whether the software
version can support this hardware
before
updating the software version
Fixes bugs
Support A-MSR20_30_50_900 series
and MSR20_30_50_900 series