26
Condition: This symptom might occur if the router learns an ARP entry that has the
same IP address, MAC address, and VLAN ID as but a different port from an existing
ARP entry.
Resolved problems in CMW520-R2314
RTD064905
Symptom: PSD fails on pair B of the fixed G.SHDSL interface on an MSR 20-13.
Condition: This symptom occurs if PSD is performed on pair B of the fixed G.SHDSL
interface on an MSR 20-13.
RTD064700
Symptom: Walking QoS statistics MIB on a VT interface MIB fails.
Condition: This symptom occurs during a walk on QoS statistics MIB on a VT interface.
RTD064568
Symptom: Service interruption occurs on a cellular interface during a 2G/3G
switchover.
Condition: This symptom can be seen during a 2G/3G switchover on a cellular
interface. The cellular interface goes down and up and then requests an IP address
again, resulting service interruption. You can use the link delay function to solve this
problem.
RTD064522
Symptom: The cwmp cpe connect interface cannot be configured as a loopback
interface.
Condition: This symptom can be seen if you configure a loopback interface as the
cwmp cpe connect interface.
Resolved problems in CMW520-R2313
RTD064439
Symptom: After the usb disable command is configured, the device cannot start up.
Condition: This symptom might occur when the usb disable command is configured.
RTD064748
Symptom: The MSR 930 router cannot recognize a Sierra250U 3G modem.
Condition: This symptom might occur when a Sierra250U 3G modem is connected to
the USB interface.
To Next Page
Loading...
Need help?
General
