HP A-MSR20 - Resolved Problems in CMW520-R2209; Resolved Problems in CMW520-R2207 P45

32
RTD59895
 Symptom: Period of time, The SIC-1T1-F card can’t receive and send packets, and the
interface queue is plugged up.
 Condition: The POE router is inserted into FSW-POE card and SIC-1T1-F card.
RTD60199
 Symptom: The SNMP OID hh3cCfgLogTerminalUser value is error.
 Condition: None.
Resolved problems in CMW520-R2209
RTD59161
 Symptom: When transmits some UDP packets, the router will reboot abnormally.
 Condition: The router runs NAT function, and there are several NAT outbound
commands at the interface of the router.
RTD58793
 Symptom: The result of NQA was inaccurate.
 Condition: Run NQA function in the Multilink PPP link with several physical interfaces.
RTD58598
 Symptom: The line protocol status of the async interface is always down.
 Condition: The aysnc interface of the router works at flow mode.
RTD59306
 Symptom: OSPF Area 0 ABR does not generate default to stub when no neighbor in
Area 0.
 Condition: Run OSPF protocol in the router.
Resolved problems in CMW520-R2207P45
RTD58789
 Symptom: If the router received challenge more than 16 bytes, the PPP CHAP
authentication failed.
 Condition: The interface of the router set PPP protocol and CHAP authentication.
RTD58508
 Symptom: The router can’t identify the INARP packets with filled information, so the
router failed to parse the IP address.
 Condition: None.