EasyManua.ls Logo

HP A-MSR20 - Resolved Problems in CMW520-R2209 P21; Resolved Problems in CMW520-R2209 P15

HP A-MSR20
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
29
RTD063433
Description: An MSR 30-11F router that performs 802.1X authentication fails to execute
permit rules in an assigned ACL.
Condition: This symptom might occur if the assigned ACL comprises both permit and
deny rules.
RTD063426
Description: An X.25 SVC fails to be established.
Condition: This symptom occurs if the call request received from the X.25 peer has a
facility ID of 00.
RTD063577
Description: A client fails to pass 802.1X authentication on the router.
Condition: This symptom occurs if the client is enabled with IP check function.
Resolved problems in CMW520-R2209P21
RTD062073
Symptom: Because the external 3G modem negotiates slowly, if the PPPoE client waits
for PPP negotiation more than 10s, the PPPoE dialer will fail.
Condition: MSR device as PPPoE client, and connected with external 3G modem.
RTD061928
Symptom: The power level measured is greater than the maximum power level
allowed by the standard 12.5dBm.
Condition: The test house carries out the Annex L testing for the SIC-ADSL card.
RTD061985
Symptom: The UMTS light on the SIC-3G-GSM or SIC-HSPA card is bright yellow all along.
Condition: The SIM card can’t be identified in the SIC-3G-GSM or SIC-HSPA.
Resolved problems in CMW520-R2209P15
RTD061429
Symptom: When modifying the parameter of tunnel bandwidth, OSPF COST doesnt
update.
Condition: The tunnel interface of the route runs OSPF protocol.
RTD61366
Symptom: The REINVITE message from the router doesnt take NTE capacity filed, so
the FAX passthrough with LYNC server fails.

Table of Contents

Other manuals for HP A-MSR20

Related product manuals