HP A-MSR20 - Using XMODEM to Upgrade Software Through the Console Port

26
............................................................................
.........................Done!
31911744 bytes downloaded!
Updating File flash:/main.bin...............................................
....................................................Done!
==========================<Enter Ethernet SubMenu>==========================
|Note:the operating device is flash |
|<1> Download Application Program To SDRAM And Run |
|<2> Update Main Application File |
|<3> Update Backup Application File |
|<4> Update Secure Application File |
|<5> Modify Ethernet Parameter |
|<0> Exit To Main Menu |
|<Ensure The Parameter Be Modified Before Downloading!> |
============================================================================
Enter your choice(0-5):
4. Enter 0 to return to the BootWare menu or 1 to boot the system.
Using XMODEM to upgrade software through the
console port
1. Enter 2 in the BootWare menu to access the Serial submenu.
===========================<Enter Serial SubMenu>===========================
|Note:the operating device is flash |
|<1> Download Application Program To SDRAM And Run |
|<2> Update Main Application File |
|<3> Update Backup Application File |
|<4> Update Secure Application File |
|<5> Modify Serial Interface Parameter |
|<0> Exit To Main Menu |
============================================================================
Enter your choice(0-5):
Table 18 Serial submenu options
Item
Description
<1> Download Application Program To SDRAM
And Run
Download an application to SDRAM through
the serial port and run the program.
<2> Update Main Application File
Upgrade the main system software image.
<3> Update Backup Application File
Upgrade the backup system software image.
<4> Update Secure Application File
Upgrade the secure system software image.
<5> Modify Serial Interface Parameter
Modify serial port parameters
<0> Exit To Main Menu
Return to the BootWare menu.
2. Select an appropriate baud rate for the console port. For example, enter 5 to select
115200 bps.
===============================<BAUDRATE SET>===============================
|Note:'*'indicates the current baudrate |