HP A-MSR20 User Manual

30
 Condition: The router runs FAX passthrough with Microsoft LYNC server.
RTD061122
 Symptom: The router doesn’t eliminate the NAT session synchronously at the router, so
that the NAT data flow can be transmitted all along.
 Condition: Remove the NAT static configuration at the router, at the same time there
are durative NAT data flow at the router.
Resolved problems in CMW520-R2209P13
RTD060728
 Symptom: Some time, the E1-F interface is UP and DOWN ceaselessly.
 Condition: A SIC-2E1-F card is inserted into the router, and the link status of one E1-F
interface is UP, the link status of the other E1-F interface is DOWN.
RTD60727
 Symptom: The router can’t detect the RPS power status accurately, so there are lots of
RPS power alarms at the LOG of the router.
 Condition: The MSR30 router with RPS power.
RTD60660
 Symptom: The pulse shape of MIM-8T1 and FIC-8T1 interface was too low.
 Condition: None.
RTD60295
 Symptom: The Power Spectral Density of the 4-Wire G.SHDL MIM can’t achieve
compliance against S043 for Australia testing.
 Condition: None.
RTD60295
 Symptom: The Power Spectral Density of the 4-Wire G.SHDL MIM can’t achieve
compliance against S043 for Australia testing.
 Condition: None.
RTD60721
 Symptom: Once the interface bearing the BGP connection is UP/DOWN, the BGP
connection will be UP/DOWN again and again, and it takes a long time to establish
the steady BGP connection.
 Condition: There are lots of BGP route policies about community attribute at the router,
and there are also many of BGP routes at the router.

HP A-MSR20 Specifications

General

Brand	HP
Model	A-MSR20
Category	Network Router
Language	English