To Next Page

To Previous Page

 Condition: None

RTD065659

 Symptom: The router can't establish the TLS connection with TLS 1.2 client.

 Condition: None

RTD065658

 Symptom:. The vad function doesn't take effect.

 Condition: Use G711 codec and set the command of "default entity vad-on".

Resolved Problems in CMW520-R2315

RTD065340

 Symptom: When the L2 switched Ethernet interface of the router is up and down, the

RIP BFD session based on the WAN interface of the router is up and down too.

 Condition: .There are several L2 switched Ethernet interfaces at the router, and these

Ethernet interfaces enable STP, at the same time the WAN interface runs RIP BFD

function.

RTD065253

 Symptom: If the router learns from a VPN an ARP entry that has the same IP address,

MAC address, and VLAN ID as but a different port from an existing ARP entry (port

migration), the CPU usage is high or an error occurs to ARP update.

 Condition: This symptom might occur if the router learns an ARP entry that has the

same IP address, MAC address, and VLAN ID as but a different port from an existing

ARP entry.

RTD065431

 Symptom: If a Lync client calls a PSTN terminal when the Lync2013 server is enabled

with PAI, the PSTN terminal cannot display the caller number and name.

 Condition: This symptom can be seen if a Lync client calls a PSTN terminal when the

Lync2013 server is enabled with PAI.

Resolved Problems in CMW520-R2312P20

HSD109708

 Symptom: If the router learns from a VPN an ARP entry that has the same IP address,

MAC address, and VLAN ID as but a different port from an existing ARP entry (port

migration), the CPU usage is high or an error occurs to ARP update.

HP A-MSR20 User Manual

Other manuals for HP A-MSR20