HP A-MSR20 - Resolved Problems in CMW520-R2105 P38; Resolved Problems in CMW520-R2105 P36

37
RTD54836
 Symptom: The call cannot be established.
 Condition: When configure the UDP as the SIP transport protocol, If the Packet is larger
than MTU-200, the transport protocol will automatically change to TCP, but if the
destination does not support TCP, the transport protocol cannot change back to UDP.
Resolved Problems in CMW520-R2105P38
RTD55551
 Symptom: All isdn calls at the four SIC-BU cards couldn’t be established successfully at
the same time.
 Condition: There were four SIC-BU cards inserted into the router.
RTD55454
 Symptom: After period of time, IPSEC data would be intermitted.
 Condition: The router transmitted IPSEC data with perfect forward secrecy function.
RTD55494
 Symptom: The static arp items are not buildrun after the arp fixup command, so the
static arp items will be lost after the device reboot.
 Condition: Run the arp fixup command and reboot the router.
Resolved Problems in CMW520-R2105P36
RTD54196
 Symptom: Even if there were several sub-interfaces at the main-interface, only one
x.121 address can be set to map x25 bridge.
 Condition: Set x25 bridge map at the interface of the router.
RTD54728
 Symptom: After mirroring the packets for a while, the memory of the router leaked.
 Condition: The source port of mirror-group was MP’s virtual-template interface.
RTD54669
 Symptom: The G.SHDSL interface still negotiated as 4-wire.
 Condition: The G.SHDSL interface of the A-MSR 20-13 was set to 2-wire mode.