A-Class System Overview and Reference
A-Class Server System Regulatory Compliance Statements
Chapter 1
19
CAUTION Users should not attempt to make such connections themselves, but should contact the
appropriate electric inspection authority, or electrician, as appropriate.
National Post and Telecom Agency Statement (Sweden only)
The LAM Interface shall be connected to SELV (max.42.4 V peak, or 60 V DC) according
to EN 60950. (The internal modem complies with this requirement.)
AUSTEL Telecom Statement (Australia only)
When setting the number of automatic redials for the modem, ensure the following:
The number of automatic redials that the modem performs should be limited to a
maximum of 9 redials plus the original call. If the above retries are unsuccessful, no
further attempts should be made to the same number for a minimum period of 5
minutes.
CAUTION Failure to set the modem, and any communication software used with the modem to the
values contained in the listing will result in the modem being operated in a
non-compliant manner. Consequently, there would be no permit in force for this
equipment, and the Telecommunications Act 1991 prescribes a penalty of A$12,000 for
the connection of non-permitted equipment.
Australian C-Tick Label
New Zealand and Telecom Statement (New Zealand only)
When using an application software that allows the setting of automatic redialing, the
following guidelines should be followed:
• Not more than five call attempts to the same number within a one hour period.
• A minimum of 60 seconds between each attempt.
• Not more than a total of 10 call attempts to the same number.
Any setting that violates the above guidelines will cause the equipment to go out of
compliance, and thus no Telepermit will be in force for this equipment which will make it
subject to penalties.
To Next Page
Loading...
Need help?
General