A-Class Server Installation
A-Class Server System Installation
Chapter 2
22
A-Class Server System Installation
Overview
The sections listed below describe the procedures you will use to prepare for, install, and
begin operation of, your A-Class server:
A-Class Server Site Preparation. Contains environmental requirements for
preparing the area where your server is to be located.
Stand-Alone A-Class Server Unpack and Install Instructions. Details what you will
find when you open the carton containing your A-Class server and how to set it up
for stand-alone operation.
Cabinet-Mounted A-Class Server System Unpack and Install. Tells you how to
install and connect the server to external devices and power, either as a stand-alone
unit or in an HP-supported cabinet. Unpacking, set up, and connection information
is also included for those who ordered a cabinet from the factory with one or more
servers installed,
A-Class Server System Software Configuration. Tells you how to install memory
(RAM), cache memory, embedded disk and I/O card add-on components.
A-Class Server Power Up and Boot Procedures. Leads you through the process for
powering up external devices and the server, gives the software commands for
customizing the A-Class Secure Web Console IP address, and lists the steps required
for booting the server to an operating state.
A-Class Server System Software Configuration. Directs you to the software
commands necessary for preparing both the A-Class server and the A-Class Secure
Web Server for operation.
To Next Page
Loading...
Need help?
General