A-Class System Service
A-Class Server RAM Removal and Replacement
Chapter 3
87
Step 3. Push the RAM board firmly and evenly into the connector until it clicks into place.
RAM Removal and Replacement Rules
• RAM boards are installed in pairs. However, if a defective board has been isolated, it
may be replaced individually with a board of the same size. For example, a 128MB
board must be replaced with another 128MB board.
• Memory is installed in the following increments:
— 128MB (two 64MB RAM boards)
— 256MB (two 128MB RAM boards)
— 512MB (two 256MB RAM boards).
• The smallest RAM pair must be installed in the lowest numbered slots, followed by
the next larger pair in the next two slots until all slots are filled. Memory slots are
configured in the order shown below:
• If a memory pair is to be installed that is larger than the largest RAM pair of the
existing configuration: remove, reorder, and reinstall all pairs according to the rules
listed above.
0 B
A
1 B
A
2 B
A
3 B
A
To Next Page
Loading...
Need help?
General