A-Class Server Installation
Stand-Alone A-Class Server Unpack and Install Instructions
Chapter 2
28
Unpack the Server
CAUTION Do not set the server on its side, or in any position other than upright on its rubber
“feet,” for operation. Failure to observe this precaution may result in component damage
or loss of system reliability.
Carefully unwrap the server and set it upright on the work surface.
Open the Accessory Kit
Open the Accessory Kit and verify that the contents agree with the packing list.
NOTE Plastic Front Anchor Bracket end caps are included in each kit. Do not discard them.
They will be needed if the server is installed in a cabinet.
Open the Installation Instructions and Regulatory Information
Packet
The Installation Instructions/Regulatory Information Packet contains the following
information:
• Installation Instruction Sheet (A5182-96002), which includes:
Basic cable connection information necessary to power on and boot the server to
the Firmware Main Menu screen.
The Universal Resource Locator (URL) for the A-Class Server home page on the
World Wide Web.
• Regulatory Information. Contains consumer safety and regulatory statements for
the United States and for those countries that require publishing and dissemination
of their own consumer safety and regulatory data.
Installing a Stand-alone System
A-Class servers are compact in design and can be installed on table or desk tops in the
same manner as any standard Personal Computer (PC).
Heating and cooling conditions must be met for the system to function at peak efficiency.
Attention must be paid to system access. There must be room for external connections on
the rear of the server and there must be ready access to an electrical outlet with the
correct electrical output. These environmental requirements are found in the section
titled, A-Class Server Site Preparation.
When you have installed the server and are ready to connect external devices, refer to
the,External Connections section.
To power up and boot the server, refer to the section titled, A-Class Server Power Up and
Boot Procedures.
To Next Page
Loading...
Need help?
General