A-Class Server Installation
Cabinet-Mounted A-Class Server System Unpack and Install
Chapter 2
29
Cabinet-Mounted A-Class Server System Unpack and
Install
Overview
A-Class servers can be procured in two modes: stand-alone or pre-installed in a cabinet
at the factory. Stand-alone servers can be configured for installation in an existing
HP-supported cabinet. The following subsections provide system installation
information:
• Information Sheet
• Installing a Factory-integrated Cabinet
• Installing a Stand-alone System in an HP-supported Cabinet
• External Connections
Information Sheet
Each system is packed with an Information Sheet that contains basic installation
instructions. Review the Information Sheet thoroughly and follow the steps listed to
perform the installation. The information sheet may refer you to the LED Interpretation
and Removal & Replacement Procedures label located inside the cover, adhered to the
top. This label provides instructions for interpreting LED combinations and information
about system components.
Installing a Factory-integrated Cabinet
Unpacking the Cabinet
NOTE It is the customer's responsibility to inspect the shipping package for damage.
It is the Hewlett-Packard Customer Engineer’s responsibility to remove the cabinet
assembly from the shipping pallet.
WARNING A fully configured 2.0 meter cabinet can weigh up to 362.8 kg (800 lbs). Be
careful not to tip the cabinet while unpacking. Failure to heed this warning
can result in serious injury or equipment destruction.
To unpack the cabinet, perform the following steps:
To Next Page
Loading...
Need help?
General