A-Class System Service
A-Class System Repair
Chapter 3
62
A-Class System Repair
Overview
The sections listed below describe the procedures you will use to identify fault conditions
in your server, troubleshoot the system, exchange the server Field Replaceable Units
(FRUs), and configure system hardware:
• “A-Class System Repair”. Describes the LED patterns displayed during normal
operation and when fault conditions occur.
• “A-Class Server Fault Condition Recognition”. This section is divided into two levels:
tasks that can be performed by customers and tasks that can only be performed by
qualified HP Field Service representatives.
• “A-Class Server Trouble Shooting”. Lists the subsections that contain procedures for
“Ordering Repair Parts for the A-Class Server”, and removing and replacing the
FRUs listed below:
— “A-Class Server RAM Removal and Replacement”
— “A-Class Server Cache Memory Removal and Replacement”
— “A-Class Server Disk Drive Removal and Replacement”
— “A-Class Server I/O Card Removal and Replacement”
— “Replacing an A-Class Server Exchange Base Unit (EBU)”.
To Next Page
Loading...
Need help?
General