A-Class System Service
Replacing an A-Class Server Exchange Base Unit (EBU)
Chapter 3
104
Locate the new bar coded sticker with A5183 markings and place it on the rear label of
the new EBU in the field marked, “Product Number” (over the A5182 text).
Reinstall the System
If the replacement A-Class server is used as a single independent unit, refer to the
Chapter 2, “A-Class Server Installation,” on page 21 subsection of the Stand-Alone
A-Class Server Unpack and Install instructions.
If the replacement server is to be re-installed in an HP-approved cabinet, refer to the
Chapter 2, “A-Class Server Installation,” on page 21 subsection of the Cabinet-Mounted
A-Class Server System Unpack and Install instructions.
When the basic reinstallation procedures are complete, refer to the Chapter 2, “A-Class
Server Installation,” on page 21 instructions to reconnect the replacement server to
external devices and power. This information is also found in the Cabinet-Mounted
A-Class Server System Unpack and Install instructions.
Restart the System
Refer to the Chapter 2, “A-Class Server Installation,” on page 21 section for applying
power to and initiating selftest on both the server and other external devices, and
booting the system.
To Next Page
Loading...
Need help?
General