A-Class System Service
A-Class Server Fault Condition Recognition
Chapter 3
64
Review Console Messages
Console messages are also used to display fault conditions on the system console if a
System Panic or HPMC fault occurs. If the memory dump function is properly
configured, a memory dump (core dump) will automatically print to a hard disk file or
other designated data storage following a System Panic, HPMC fault, or Transfer Of
Control (TOC). Refer to the A-Class Server Trouble Shooting section for more
information regarding TOC. If an A3342A HSC Remote Management card (Access Port)
is installed, additional system status information, including selftest status messages,
can be displayed at the console and, during normal operation (with HP-UX running),
system status information can also be displayed by entering a Control B command. HSC
Remote Management card system status information appears on the console in the
format below.Refer to the A-Class Server Trouble Shooting section for definitions of the
data provided by the HSC Remote Management card.
RUN F01F REMOTE: disabled inactive multiple ACCESS FLT: 00
CM>
To Next Page
Loading...
Need help?
General