A-Class Server Installation
Cabinet-Mounted A-Class Server System Unpack and Install
Chapter 2
40
Connect Power Cords
CAUTION Do not press and hold the Web Console Reset button (located on the rear of the server
between the LAN Web Console receptacle and the ASCII terminal receptacle) while
connecting the server power cord. Failure to observe this precaution will cause erasure of
all settings in the Web Console that is connected to the server.
Connect the power cord that is provided with the system to the server. For stand-alone
servers, the power cord will be localized to each country’s power application. If an HP
Uninterruptible Power Supply (UPS) is the power source, use the power cord provided
with the UPS. If an HSC Remote Management card is installed in the server, use the
cable provided with the HP UPS to connect the RS232 serial port to the port labeled
“UPS” on the HSC Remote Management card.
Connect power cords to all external devices at this time with the localized power cord,
cabinet power cord, or the UPS power cord.
For cabinet mounted servers, the server power cord connects to the C13 connector of the
Power Distribution Unit in the cabinet.
To Next Page
Loading...
Need help?
General