HP A5120 EI Series

34
Item
Description
3. Display all files in flash
Display all files in the Flash memory.
4. Delete file from flash
Delete files from the Flash memory.
5. Modify bootrom password
Modify the Boot ROM password.
6. Enter bootrom upgrade menu
Access the Boot ROM update menu.
7. Skip current configuration file
Start the switch with the factory default configuration. This is a one-
time operation and does not take effect at the next reboot. You use
this option when you forget the console login password.
8. Set bootrom password recovery
Disable or enable the Boot ROM password recovery function. By
default, Boot ROM recovery is enabled. You can disable this
function to protect system security.
9. Set switch startup mode
Set the startup mode to full mode or fast mode, as described in
"Changing the startup mode."
0. Reboot
Restart the switch.
NOTE:
The system by default has no Boot ROM password. HP recommends that you set a Boot ROM password
immediately after you access the Boot menu.
4. If you perform no operation or press any key other than Ctrl + B within one second:
a. the system automatically starts up when the remaining time becomes zero, and displays the
following information:
Auto-booting...
Decompress Image................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
...........................................OK!
User interface aux0 is available.
Press ENTER to get started.