To Next Page

To Previous Page

4-22

Web and MAC Authentication

Configuring Web Authentication

Syntax: [no] aaa port-access web-based <port-list>

Enables web-based authentication on the specified

ports. Use the no form of the command to disable web-

based authentication on the specified ports.

Syntax: aaa port-access web-based <port-list> [auth-vid <vid>]]

no aaa port-access web-based <port-list> [auth-vid]

Specifies the VLAN to use for an authorized client. The

Radius server can override the value (accept-response

includes a vid). If auth-vid is 0, no VLAN changes occur

unless the RADIUS server supplies one.

Use the no form of the command to set the auth-vid to 0.

(Default: 0).

Syntax: aaa port-access web-based [clear-statistics]

Clears (resets to 0) all counters used to monitor the

CEI, HTTP, Web-Auth control traffic generated in web

authentication session. (To display Web-Auth traffic

statistics, enter the show port-access web-based statis-

tics command.)

Syntax: aaa port-access web-based <port-list > [client-limit <1-256>]

Specifies the maximum number of authenticated cli-

ents to allow on the port. (Default: 1)

Note: On switches where Web Auth and 802.1X can

operate concurrently, this limit includes the total num-

ber of clients authenticated through both methods. The

limit of 256 clients only applies when there are fewer

than 16,384 authentication clients on the entire

switch. After the limit of 16, 384 clients is reached, no

additional authentication clients are allowed on any

port for any method.

Questions and Answers:

Need help?

Do you have a question about the HP E3800 Series and is the answer not in the manual?

HP E3800 Series Specifications

General