8. Lift the heat sink from atop the processor and set it on its side to keep from contaminating the
work area with thermal grease.
When reinstalling the heat sink, make sure that its bottom has been cleaned with an alcohol wipe and
fresh thermal grease has been applied to the top of the processor.
CAUTION: Heat sink retaining screws should be tightened in diagonally opposite pairs (as in an X)
to evenly seat the heat sink on the processor to avoid damage that could require replacing the system
board.
Failure to install the baffle may cause the computer to overheat.
Heat sink 103
To Next Page
Loading...
