Front bezel security
The front bezel can be locked in place by installing a security screw provided by HP. To install the
security screw:
1. Prepare the computer for disassembly (
Preparation for disassembly on page 66).
2. Remove the access panel (
Access panel on page 67).
3. Remove one of the five silver 6-32 standard screws located on top of the drive cage.
4. Install the security screw through the middle front bezel release tab to secure the front bezel in
place.
5. Replace the access panel.
6. If the computer was on a stand, replace the stand.
68 Chapter 6 Removal and replacement procedures – small form factor (SFF) chassis
To Next Page
Loading...
Need help?
General