5-2 Chapter5
Language Reference
The commands are listed in alphabetical order and grouped by function
within the subsystem in which they belong.
The first few pages of this chapter contain common commands specified
in IEEE Standard 488.2-1992, IEEE Standard Codes, Formats,
Protocols and Common Commands for Use with ANSI/IEEE Std
488.1-1987. New York, NY, 1992. Following these commands, the HP
ESA spectrum analyzers SCPI commands are listed.
NOTE Refer to Chapter 2, “Status Registers,” and the status messages in
Chapter 7, “Error Messages,” which supplements the information
presented in this chapter. In addition, refer to Chapter 6, “Front Panel
Key Reference” in the HP ESA Spectrum Analyzers User’s Guide for
additional information about the operation of each analyzer function.
Use the analyzer
HELP key to obtain similar information about
analyzer key functions.
The SCPI subsystems used are:
ABORt
CALCulate
CALibration
CONFigure
COUPle
DISPlay
FETCh
FORMat
HCOPy
INITiate
INPut
MEASure
MMEMory
OUTPut
READ
SENSe
SOURce
STATus
SYSTem
TRACe
To Next Page
