HP ESA-E Series - Trigger Subsystem; Rear Panel External Trigger Delay Value; Rear Panel External Trigger Delay; Rear Panel External Trigger Slope

Chapter 5 5-129
Language Reference
TRIGger Subsystem
TRIGger Subsystem
The TRIGger subsystem is used to set the controls and parameters
associated with triggering the data acquisitions. Other trigger-related
commands are found in the INITiate and ABORt subsystems.
Rear Panel External Trigger Delay Value
:TRIGger[:SEQuence]:[1]:DELay <level>
:TRIGger[:SEQuence]:[1]:DELay?
Set the amount of trigger delay when using the rear panel external
trigger input.
Factory Preset
and *RST: 0 s
Range: 0.3 µs to 429 seconds
Default Unit: seconds
Front Panel
Access:
Trig, Trig Delay On Off
Rear Panel External Trigger Delay
:TRIGger[:SEQuence]:[1]:DELay:STATe OFF|ON|0|1
:TRIGger[:SEQuence]:[1]:DELay:STATe?
Turns the trigger delay on/off without changing the current delay
setting.
Factory Preset
and *RST: Off
Default Unit: seconds
Rear Panel External Trigger Slope
:TRIGger[:SEQuence]:EXTernal[1]:SLOPe POSitive|NEGative
:TRIGger[:SEQuence]:EXTernal[1]:SLOPe?
Sets the triggering to occur on a positive-going edge or a negative-going
edge of the trigger when using the rear panel external trigger input.
Factory Preset
and *RST: Positive
Front Panel
Access:
Trig, External Pos Neg