HP ESA-E Series - Save; Service Request Enable; Read Status Byte Query; Trigger

Chapter 5 5-7
Language Reference
IEEE Common Commands
Save
*SAV <register>
This command saves the instrument state to the specified instrument
memory register.
Range: Registers are an integer, 2 to 30
Remarks: See also commands :MMEMory:LOAD:STATe and
:MMEMory:STORe:STATe
Front Panel
Access:
File, Save State
Service Request Enable
*SRE <integer>
*SRE?
This command sets the value of the service request enable register.
The query returns the value of the register.
Range: Integer, 0 to 255
Read Status Byte Query
*STB?
Returns the value of the status byte register without erasing its
contents.
Remarks: See *CLS
Trigger
*TRG
This command triggers the instrument. Use the
:TRIGger:SEQuence:SOURce command to select the trigger source.
Remarks: See also the :INITiate:IMMediate command
Self Test Query
*TST?
This query is used by some instruments for a self test.
For HP ESA analyzers, *TST? always returns 0; no tests are performed.
Front Panel
Access:
System, Alignments, Align All Now