HP ESA-E Series - Trace Math Subtract from Display Line; Select Trace Display Mode

5-128 Chapter5
Language Reference
TRACe Subsystem
Example: :TRAC:MATH:SUBT TRACE3,TRACE3,TRACE2
is equivalent to: (trace 3 = trace 3 − trace 2)
Trace Math Subtract From Display Line
:TRACe:MATH:SUBTract:DLINe <trace>
Subtracts the magnitude of the display line from the selected trace and
places the result back in the selected trace.
Trace is: TRACE[1|2|3]
Example: :TRAC:MATH:SUBT:DLIN TRACE1
is equivalent to: (trace1 = trace 1 − display line)
Front Panel
Access:
View/Trace, Operations, 2 – DL –> 2
Select Trace Display Mode
:TRACe[1]|2|3:MODE WRITe|MAXHold|MINHold|VIEW|BLANk
:TRACe[1]|2|3:MODE?
Selects the display mode for the selected trace.
Write puts the trace in the normal mode, updating the data.
Maximum hold displays the highest measured trace value for all the
data that has been measured since the function was turned on.
Minimum hold displays the lowest measured trace value for all the
data that has been measured since the function was turned on.
View turns on the trace data so that it can be viewed on the display.
Blank turns off the trace data so that it is not viewed on the display.
Front Panel
Access:
View/Trace, Clear Write
View/Trace, Max Hold
View/Trace, Min Hold
View/Trace, View
View/Trace, Blank