HP ESA-E Series - Operation Negative Transition; Operation Positive Transition; Preset the Status Byte

Chapter 5 5-107
Language Reference
STATus Subsystem
Operation Negative Transition
:STATus:OPERation:NTRansition <number>|<non-decimal
numeric>
:STATus:OPERation:NTRansition?
This command determines what bits in the Operation Condition
register will set the corresponding bit in the Operation Event register
when that bit has a negative transition (1 to 0). The variable <number>
is the sum of the decimal values of the bits that you want to enable.
Factory Preset
and *RST: 0
Range: 0 to 32767
Operation Positive Transition
:STATus:OPERation:PTRansition <number>|<non-decimal
numeric>
:STATus:OPERation:PTRansition?
This command determines what bits in the Operation Condition
register will set the corresponding bit in the Operation Event register
when that bit has a positive transition (0 to 1). The variable <number>
is the sum of the decimal values of the bits that you want to enable.
Factory Preset
and *RST: 32767 (all 1’s)
Range: 0 to 32767
Preset the Status Byte
:STATus:PRESet
Sets bits in most of the enable and transition registers to their default
state. It presets all the Transition Filters, Enable Registers, and the
Error/Event Queue Enable. It has no effect on Event Registers,
Error/Event Queue ESE, and SRE Registers as described in IEEE
Standard 488.2-1992, IEEE Standard Codes, Formats, Protocols and
Common Commands for Use with ANSI/IEEE Std 488.1-1987. New
York, NY, 1992.