HP ESA-E Series - Page 42

2-12 Chapter2
HP ESA Status Registers
Using the Analyzer Status Registers
Standard Event Status Register
The Standard Event Status Register is used to determine the specific
event that sets bit 5 in the Status Byte Register. The Standard Event
Status Register does not have negative and positive transition
registers, nor a condition register. Use the IEEE common commands at
the beginning of the “Language Reference” chapter in this guide to
access the register. It contains the following bits:
+
To Status Byte Register Bit #5
&
&
&
&
&
&
&
&
Request Bus Control
Operation Complete
Query Error
Device Dependent Error
Execution Error
Command Error
User Request
Event Register
Event
Enable Register
Power On
ck723a
01234567
01234567