You can specify the network interface card (NIC) for PXE to use to communicate with the RIS
server. When the HP Integrity server boots from this NIC, it effectively boots from the remote
RIS server. Working in conjunction with the RIS server, PXE installs a new image of the Windows
Server 2003 on the HP Integrity server.
To enable PXE on the HP Integrity server from the EFI Shell, complete the following steps:
1. From the EFI Boot Manager, select EFI Shell. The device mapping table appears.
2. Enter the lanboot select command.
3. At the Select desired LAN: prompt, enter the number of the NIC card connected to
the PXE server.
4. Exit the EFI Shell.
Preparing the server hardware 33
To Next Page
Loading...
Need help?
General