HP Integrity rx1620 Software Guide

• MODEM PROTOCOL: Bell or CCITT. CCITT is a European standard; RTS/CTS signaling is
used as well as the Ring signal. Bell is a U.S. or simple mode.
• BAUD RATES: Input and output data rates are the same — 300, 1200, 2400, 4800, 9600, 38400,
115200 bit/sec.
• FLOW CONTROL: Hardware uses RTS/CTS; software uses Xon/Xoff.
• TRANSMIT CONFIGURATION STRINGS: Disable this setting whenever the modem being
used is not compatible with the supported modem (MT5634ZBA).
• MODEM PRESENCE: When the modem is not always connected, set this parameter to not
always connected.
CG — Generates an RSA key pair or Self-Signed Certificate. This command generates a new RSA
key pair and self-signed certificate.
CL — Console Log. View the history of the console output. This command displays up to 60 KB
of logged console data (about 60 pages of display in text mode) sent from the system to the
console path.
CM — Command Mode. Enter command mode. This command switches the console terminal
from the MP Main Menu to mirrored command interface mode. If the current mux authority is
administrator and the new login is as an operator, the command mux is denied (remains in MP
Main Menu mode). If a command is in progress, a message is displayed warning the new user
of system status.
CO — Console. Leave command mode and enter console mode. This command switches the
console terminal from the MP Main Menu to mirrored (redirected) console mode. All mirrored
data is displayed. Press CTRL+B to return to the MP command interface.
For VT100 and HPTERM, verify that the MP setting in the CO command is correct and that all
mirrored consoles are of the same terminal type for proper operation.
CSP — Connects to a remote MP over the LAN. This command enables the local or remote port
user to connect over the MP LAN to another MP on the network. The user who launches the
command is given a private connection to the other MP over the LAN. To return to the original
MP, press CTRL+] to disconnect the CSP session.
DATE — Displays the current date, as generated in the MP real-time clock.
DC — Default Configuration. Resets all MP parameters to the default configuration. This command
sets all MP parameters back to their default values. You can reset all or a subset of the following
parameters:
• IP configurations
• Modem configuration
• Paging configuration
• Command interface configuration
• Disable remote access, security configuration
• Session configuration, for example, setting the security configuration to default erases all
users and passwords
You can reset passwords in the MP in the following ways:
— Method 1: Using the SO command, change individual users.
— Method 2: Using the DC command, select Reset Security Configuration.
— Method 3: Reset forgotten passwords by pressing the MP reset button on the back panel
of the HP Server. After the MP reboots, the local console terminal displays a message
for 5 seconds. Responding to this message in time allows a local user to reset the
password.
NOTE: All user information (logins, passwords, and so on) is erased in methods 2 and 3.
DF — Displays FRUID information. This command displays FRUID information from the BMC
for FRU devices. Information provided includes serial number, part number, model designation,
name and version number, and manufacturer.
90 Management processor and Special Administration Console

HP Integrity rx1620 Specifications

General

Brand	HP
Model	Integrity rx1620
Category	Server
Language	English