2.3.2
System Configuration commands
mac-age-time <1..100000>
Sets the number of seconds a MAC address stays in the switch address table before
being aged out. Aging out occurs if traffic isn't received from that MAC station
within the age interval. The default value is 300.
console [terminal <vt100 | ansi> [screen-refresh <value>] [events <none | all | non-
info | critical | debug>] [baud-rate <value>] [flow-control <xon/xoff | none>]
[inactivity <value>]
Sets the console parameters.
Parameters:
terminal <vt100 | ansi> - Type of terminal being used (default is vt100).
screen-refresh <1|3|5|10|20|30|45|60> - Sets the number of seconds before a
refresh is done on the “Status and Counters” screens (default is 3).
events <none | all | non-info | critical | debug>] – The level of Switch events
displayed in Events Log. all - display all; none - display no events; not-info - display
all events except informational-only; critical - display only critical-level events;
debug (reserved for Internal use only).
baud-rate <speed-sense | 1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600
| 115200>] - Sets the data transmission speed for switch connect sessions initiated
through the Console port. Default is speed-sense.
flow-control <xon/xoff | none> - Flow Control Method; default is xon-xoff.
inactivity-timer <0 | 1 | 5 | 10 | 15 | 20 | 30 | 60 | 120> - Sets the number of
minutes of inactivity allowed by the switch before the switch will terminate the
communication session. 0 means never terminate the session; default is 0 .
[no] auto-tftp <ip-addr filename>
Enables/disables automatic OS image download via TFTP.
14
To Next Page
Loading...
