----
auto <port-list>
Causes each port identified in the port-list to learn their VLAN membership using
the Group VLAN Registration Protocol (GVRP). This command is only valid when
GVRP is enabled.
2.14 GVRP
2.14.1 GVRP commands - EXEC level
show gvrp
Displays the current VLANs.
Output Format:
Switch Configuration - GVRP Information
GVRP Enabled [No] : Yes
Port Type | Unknown VLAN
-------- + ------------
A1 10/100TX | Learn
A2 10/100TX | Learn
A3 10/100TX | Learn
A4 10/100TX | Learn
2.14.2 GVRP commands – Configuration level
[no] gvrp
Enables the Group VLAN Registration Protocol (GVRP) on the switch.
2.14.3 Ethernet Interface Configuration commands
unknown-vlans <learn | block |disable>
Defines what the port will do when it encounters GVRP packet requested it to join a
VLAN. If learn is specified then the port will join the advertised VLAN and
propagate a VLAN join requests through all other forwarding ports that are
participating in GVRP. If block is specified then the port will not join the advertised
VLAN and will not propagate any VLAN joins for the advertised VLAN.
38
To Next Page
Loading...
