EasyManuals Logo

HP ProDesk 400 G2 User Manual

HP ProDesk 400 G2
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #136 background imageLoading...
Page #136 background image
9 Password security and resetting CMOS
This computer supports security password features, which can be established through the Computer Setup
Utilities menu.
This computer supports two security password features that are established through the Computer Setup
Utilities menu: setup password and power-on password. When you establish only a setup password, any user
can access all the information on the computer except Computer Setup. When you establish only a power-on
password, the power-on password is required to access Computer Setup and any other information on the
computer. When you establish both passwords, only the setup password will give you access to Computer
Setup.
When both passwords are set, the setup password can also be used in place of the power-on password as an
override to log in to the computer. This is a useful feature for a network administrator.
If you forget the password for the computer, you can clear that password so you can gain access to the
information on the computer by resetting the password jumper.
CAUTION: Pushing the CMOS button will reset CMOS values to factory defaults. It is important to back up
the computer CMOS settings before resetting them in case they are needed later. Back up is easily done
through Computer Setup. See
Computer Setup (F10) Utility on page 73 for information on backing up the
CMOS settings.
Resetting the password jumper
CAUTION: If you enable the stringent security feature in Computer Setup and you forget the setup
password or the power-on password, the computer is inaccessible and can no longer be used.
Enabling the stringent password disables the ability to reset the password by moving the jumper on the
system board.
If you lose or forget the password, the system board must be replaced. This scenario is not covered under
warranty.
To prevent the computer from becoming permanently unusable, record your configured setup password or
power-on password in a safe place away from your computer. Without these passwords, the computer
cannot be unlocked.
To disable the power-on or setup password features, or to clear the power-on or setup passwords, complete
the following steps:
126 Chapter 9 Password security and resetting CMOS

Table of Contents

Other manuals for HP ProDesk 400 G2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProDesk 400 G2 and is the answer not in the manual?

HP ProDesk 400 G2 Specifications

General IconGeneral
Tcase72 °C
Bus typeDMI2
SteppingC0
Processor cache2 MB
Processor cores2
Processor modelG1840
System bus rate5 GT/s
Processor familyIntel® Celeron® G
Processor seriesIntel Celeron Processor G1000 Series for Desktop
Processor socketLGA 1150 (Socket H3)
Processor codenameHaswell
Processor frequency2.8 GHz
Processor cache typeL2
Processor lithography22 nm
Processor manufacturerIntel
Processor front side bus- MHz
PCI Express slots version3.0
Processor operating modes32-bit, 64-bit
ECC supported by processorYes
PCI Express configurations1x16, 2x8, 1x8+2x4
Thermal Design Power (TDP)54, 53 W
Number of processors installed1
Maximum number of PCI Express lanes16
Memory types supported by processorDDR3-SDRAM
Memory clock speeds supported by processor1333 MHz
Memory bandwidth supported by processor (max)21.3 GB/s
Maximum internal memory supported by processor32 GB
Memory slots2x DIMM
Internal memory4 GB
Memory channelsDual-channel
Memory clock speed1600 MHz
Internal memory typeDDR3L-SDRAM
Memory layout (slots x size)1 x 4 GB
Storage mediaHDD
Optical drive typeDVD Super Multi
Card reader integratedNo
Total storage capacity500 GB
Discrete graphics card modelNot available
On-board graphics card modelIntel® HD Graphics
Maximum on-board graphics card memory1.024 GB
On-board graphics card OpenGL version4.3
On-board graphics card base frequency350 MHz
On-board graphics card DirectX version11.1
On-board graphics card dynamic frequency (max)1050 MHz
Number of displays supported (on-board graphics)3
Ethernet LAN data rates10, 100, 1000 Mbit/s
USB 2.0 ports quantity6
USB 3.2 Gen 1 (3.1 Gen 1) Type-C ports quantity0
Power supply180 W
Product typePC
Market positioningBusiness
Chassis typeDesktop
Product colorBlack
Country of originChina
Placement supportedHorizontal
Sustainability certificatesENERGY STAR
Operating system installedWindows 7 Professional
Operating system architecture64-bit
Scalability1S
Processor codeSR1VK
Processor ARK ID80800
Processor package size37.5 x 37.5 mm
Supported instruction setsSSE4.1, SSE4.2
Thermal solution specificationPCG 2013C
Intel Secure Key Technology version1.00
Intel Stable Image Platform Program (SIPP) version0.00
Intel segment taggingEnterprise, Small Business
Weight and Dimensions IconWeight and Dimensions
Depth358.8 mm
Width165 mm
Height355 mm
Weight6500 g

Related product manuals