HP ProLiant BL30p

Server Blade Troubleshooting
Table A-2: Is the Server Blade Power on/standby LED Illuminated? continued
Answer Possible Reasons Possible Solutions
• Move the server blade and sleeve into a
different slot to determine if the server
blade, the server blade sleeve, or the
server blade enclosure is the source of
the problem.
• Contact an authorized service provider
for replacement parts and service.
Yes If the power on/standby LED is illuminated,
refer to Table A-3.
Note: For LED locations and functions, refer to “Front Panel LEDs, Button, and Port” in Chapter 1,
“Server Blade Component Identification.” For cabling configurations, refer to Chapter 6, “Connecting
Local I/O Devices.” For blade sleeve and server blade LED troubleshooting information, refer to
“Server Blade and Blade Sleeve Power Troubleshooting” in this appendix for more information.
HP ProLiant BL30p Server Blade Setup and Installation Guide A-7