EasyManuals Logo

HP ProLiant BL620c - G7 Server User Manual

HP ProLiant BL620c - G7 Server
190 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #144 background imageLoading...
Page #144 background image
Error messages 144
1733-Slot X Drive Array - Storage Enclosure Firmware Upgrade Problem
Detected...
...Port x box y: Enclosure firmware upgrade needed - run Flash Components.
Port x box y: Unable to read firmware version of one or more components
Audible Beeps: None
Possible Cause: An incorrect enclosure firmware version is installed, or an enclosure firmware upgrade is
needed.
Action:
Upgrade the enclosure firmware and the controller firmware.
If the condition persists, then replace the enclosure components.
For more information, see the HP BladeSystem c-Class Enclosure Troubleshooting Guide on the HP website
(http://www.hp.com/support/BladeSystem_Enclosure_TSG_en
).
1735-Slot z Drive Array - Unsupported Redundant Cabling Configuration
Detected...
...Multiple paths to the same enclosure/drives are not supported by this Smart Array firmware version. Access to all
drives has been disabled until redundant SAS cable(s) are detached, or firmware is updated to a version that
supports dual-domain.
Audible Beeps: None
Possible Cause: An unsupported redundant cabling configuration for the Smart Array firmware version is
installed.
Action: Disconnect the redundant SAS cables, and then update the Smart Array firmware to the correct
version.
1736-HP Trusted Platform Module Error
Audible Beeps: 2 short
Possible Cause: A TPM is installed, but the System ROM is unable to communicate with the TPM.
Action: Request a new system board and TPM board from an HP authorized service provider ("Contacting
HP technical support or an authorized reseller" on page 173).
When installing or replacing a TPM, observe the following guidelines:
Do not remove an installed TPM. Once installed, the TPM becomes a permanent part of the system
board.
When installing or replacing hardware, HP service providers cannot enable the TPM or the
encryption technology. For security reasons, only the customer can enable these features.
When returning a system board for service replacement, do not remove the TPM from the system
board. When requested, HP Service provides a TPM with the spare system board.
Any attempt to remove an installed TPM from the system board breaks or disfigures the TPM security
rivet. Upon locating a broken or disfigured rivet on an installed TPM, administrators should consider
the system compromised and take appropriate measures to ensure the integrity of the system data.
When using BitLocker™, always retain the recovery key/password. The recovery key/password is
required to enter Recovery Mode after BitLocker™ detects a possible compromise of system integrity.

Table of Contents

Other manuals for HP ProLiant BL620c - G7 Server

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProLiant BL620c - G7 Server and is the answer not in the manual?

HP ProLiant BL620c - G7 Server Specifications

General IconGeneral
BrandHP
ModelProLiant BL620c - G7 Server
CategoryServer
LanguageEnglish

Related product manuals