Removal and replacement procedures 34
2.
Extend or remove the server from the rack ("Remove the server from the rack" on page 27, "Extend the
server from the rack" on page 27).
3. Remove the access panel ("Access panel" on page 33).
4. Disconnect the cable from the optical drive.
5. Remove the optical drive.
To replace the component, reverse the removal procedure.
Optical drive cage
To remove the component:
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
1. Power down the server (on page 26).
To Next Page
Loading...
